Each piece of jewelry designers and manufacturers are into the soul , they need to be very complicated birth process steps . Here we will introduce you to a diamond ring the entire process from design to finished product .
Steps / methods
The concept and design : designers will own hand-drawn sketch ideas , sketches and then use mapping software to draw the exact dimensions computer to complete the initial design drawings.
Craftsman carving wax : jewelry craftsmen hand-carved out of the reference design drawings Laban , reuse lost wax casting method poured silver version, and Laban bulk silver version is required to suppress the production of rubber mold . This is the jewelry making process demanding process , the system must be clean and no trace of silver version , ministries
On a reasonable structure , inlaid stones the size of the position accuracy .
Plastic injection molding wax : the wax will be injected into the rubber mold open well after the operation . Wax wax injection machine should be kept between 70-75 degrees, the wax was injected into the film, after removing the cooling wax , followed by repetition, to get pieces of wax .
With the selection of stone : According silver version and wax , pick the size , shape and color with the right stone .
Completion of wax : Prepare all of the required Laban batch production.
Wax tree : the wax ring for each hand separately welded onto a wax stick, finally get a tree wax tree shaped like trees , ready for casting .
Said wax tree : first before the chassis wax rubber trees were weighed again finished wax tree weighing, weighing the results of the two can be derived by subtracting the weight of the wax tree wax tree under the weight of gold or silver the density -scaling the amount of the metal casting come .
Filling plaster : a good wax tree species will put together even stainless steel tube chassis and steel tube wall along the gypsum slurry slowly into the appropriate weight , not over wax tree , naturally prevent 6-12 hours after the evacuation , gypsum solidification .
Baking plaster : plaster mold for baking , is to dewaxing, drying and casting insulation.
Remove the plaster mold : Remove the baked good cast , and also ready to cast metal solution needs .
Pouring liquid gold : with a good Goldwater would have melted from the injection nozzle .
Centrifugal casting process : using vacuum induction centrifugal casting machine casting .
Washing and cleaning fried plaster mold : plaster mold after casting high temperature state , place 10-30 minutes after casting machine removed from nature, then into cold water to wash bombing carried out . Due to the contraction burst plaster , remove the gold tree , steel brush to chunks of plaster , immersed into 30% hydrofluoric acid
Soak for 10 minutes, after the clip out washing to remove excess plaster until golden tree surfaces clean.
Cut Casting : gold jewelry tree cut along the bottom nozzle dry .
Drum polishing process : stainless steel abrasive and active organic synthesis solution into the drum , with the rotational friction surface smooth and bright .
Calendering process: calender all in manually , with a special knife in the jewelry surface calender driven back and forth , this process requires certain skills and tactics.
Polishing process : Use jewelry polishing machine for grinding polished until the surface is smooth and bright .
Selection of diamond : diamond sorting by hand , picked the right color, cut, size match in preparation for the mosaic .
Diamonds : each one hand-set diamonds .
Quality control: making good jewelry, fine individually tested to ensure that qualified quality.