1 hit version : a version of the master is to get hit with copper sheet size model out .
2 film : to lay the child version with the version of the film a little child into the mold frame covered with laminated machine pressed ( by the time the film ’s custom blocks ) to suppress the mold with a scalpel to complete a professional little separated during wax injection .
3 Note Wax : Just open a good wax injection mold used repeatedly into a wax will pull out . Wax injection machine is a specialized soluble wax and the wax poured into the mold of a machine .
4 repair wax : the wax should be fine to pull out of the fix , the bad or burrs can repair system .
5 trees : the future of each candle wax repaired in one or more teeth are planted on .
6 poured gypsum : playing with tin can be set Fortunately , gypsum powder and how much prescribed amount of water and stirred with a mixer ( also specified time , the time not more , nor less ) and then on the vibration machine aims get out of the inside of the bubble ( also specified time ) gypsum
To place half an hour in order to lay the plaster . Wax injection machine
7 dewaxing furnace : one jar to lay plaster dewaxing furnace into the inside of the wax completely get out , at least 45 minutes to an hour .
8 furnaces : from dewaxing get into the high-temperature furnace fired oven around 9 hours.
9 foundry : each can be put into a copper torch burning liquid into the jars . ( Burn a copper pour a jar can not burn down a lot of products in each jar that will be very bad . Wax injection machine
10 red plaster : foundry goods which are cast out one by one rinse with water cannons .
11 shear units : the cans with pliers in each of the parts do not cut each be cut .
12 Executive mill : Crane tied sandpaper polished each product . ( This process is dirty, get body is copper ash ) 13 polished : one with a good product to wear linen cloth wheel polishing wheel plus polishing wax . ( Ie the product is smooth throw throw light )
14 Packaging : If the guest does not require plating so that you can package shipments requiring electroplating electroplating electroplating factory , then get back to what you can pack the goods seized . Wax injection machine